Section 1 Introduction
1.1 This manual
The engineering manual contains instructions on how to engineer the protection relays
using the different tools in PCM600. The manual provides instructions on how to set up
a PCM600 project and insert relays to the project structure. The manual also recommends
a sequence for engineering of protection and control functions, LHMI functions as well as
communication engineering for IEC 61850 and other supported protocols.
1.2 Intended audience
This manual addresses system and project engineers involved in the engineering process
of a project, and installation and commissioning personnel, who use technical data during
engineering, installation and commissioning, and in normal service.
The system engineer must have a thorough knowledge of the application, protection and
control equipment and the configured functional logic in the relays. The installation and
commissioning personnel must have a basic knowledge of handling electronic equipment.
1MAC108982-MB E Section 1
Introduction
615 series ANSI 5
Engineering Manual
To Next Page
Loading...
