ABB Relion 615 series - Page 139

Function IEC 61850 Logical device Logical nodes in
Ver.5.0 FP1
Logical nodes in
Ver.4.2 or older
General security application GSAL LD0 GSAL GSAL
Binary signal transfer BSTGGIO LD0 BSTGGIO BSTGGIO
Time synchronization and local time GNRLLTMS LD0
GNRLLTMS
1)
GNRLLTIM
GNRLLTMS
Controllable logic
Minimum pulse timer TPGAPC TPGAPC TPGAPC
Minimum pulse timer TPSGAPC TPSGAPC TPSGAPC
Minimum pulse timer TPMGAPC TPMGAPC TPMGAPC
Pulse timer PTGAPC PTGAPC PTGAPC
Time delay off TOFGAPC TOFGAPC TOFGAPC
Time delay on TONGAPC TONGAPC TONGAPC
Set-reset SRGAPC SRGAPC SRGAPC
Move MVGAPC MVGAPC MVGAPC
Generic control point SPCGAPC SPCGAPC SPCGGIO
Analog value scaling SCA4GAPC SCA4GAPC SCA4GAPC
Integer value move MVI4GAPC MVI4GAPC MVI4GAPC
Protocols
IEC 61850 MMSLPRT LD0 MMSLPRT MMSGGIO
GOOSE GSELPRT LD0 GSELPRT GSEGGIO
MODBUS MBSLPRT LD0 MBSLPRT MBSLPRT
DNP 3.0 DNPLPRT LD0 DNPLPRT DNPLPRT
IEC 103 I3CLPRT LD0 I3CLPRT I3CLPRT
Hardware
PSM (X100) card X100 (PSM) LD0 XGGIO100 XGGIO100
BIO (X110) card X110 (BIO) LD0 XGGIO110 XGGIO110
BIO (X110) high speed output X110 (BIO-H) LD0 XBGGIO110 XBGGIO110
AIM (X120) 4CT with Io X120 (AIM) LD0 XGGIO120 XGGIO120
AIM (X120) 4CT with sensitive Io X120 (AIM) LD0 XGGIO120 XGGIO120
AIM (X120) 4CT with Uo X120 (AIM) LD0 XGGIO120 XGGIO120
AIM (X120) 7CT with Io X120 (AIM2) LD0 XAGGIO120 XAGGIO120
AIM (X120) 7CT with sensitive Io X120 (AIM2) LD0 XAGGIO120 XAGGIO120
AIM (X120) 4CT_3VT with Io X120 (AIM2) LD0 XAGGIO120 XAGGIO120
AIM (X120) 4CT_3VT with sensitive Io X120 (AIM2) LD0 XAGGIO120 XAGGIO120
AIM (X130) 5 VT X130 (AIM) LD0 XAGGIO130 XAGGIO130
AIM (X130) 5 VT, 2RTD and 1mA X130 (AIM+RTD) LD0 XARGGIO130 XARGGIO130
SIM (X130) 3Is_3Us with sensitive Io X130 (SIM) LD0 XSGGIO130 XSGGIO130
Table continues on next page
1MAC108982-MB E Section 7
IEC 61850 communication engineering
615 series ANSI 131
Engineering Manual