• The communication engineering details are protocol-dependent.
• The connectivity package creates the IEC 61850 configuration for vertical
communication automatically and it is directly suitable, in most cases, for IEC 61850
client configuration. Either IEC 61850 Configuration tool or IET600 is needed for
configuring horizontal and vertical communication.
• The Communication Management tool is used for communication protocols; for
example, Modbus and DNP3.
The protection relay restarts automatically when writing a relay
configuration where changes have been made. It is not possible to
communicate with the protection relay during restart.
1MAC108982-MB E Section 2
Relay engineering process
615 series ANSI 23
Engineering Manual
To Next Page
Loading...
