4.4 Setting the IED IP address in a project
The IP address and subnet mask of the IED object in PCM600 must match the front and
rear port of the protection relay (physical IED) to which the PC is connected. The IP
address of the protection relay can only be set via the LHMI or Parameter Setting tool in
PCM600. The PC and protection relay need to be on the same subnet.
There are two alternatives to set the IP address of an IED object in PCM600.
• On the first page of the wizard when including a new IED into a project.
• In the IP address box of the IED's Object Properties dialog box.
GUID-0C8D23CA-5BB5-4D36-9B11-245B5465D9E1-ANSI V1 EN
Figure 36: Alternative 1: Setting the IP address on the first wizard page
Section 4 1MAC108982-MB E
Setting up a project
64 615 series ANSI
Engineering Manual
To Next Page
Loading...
