To establish a remote WHMI connection to the protection relay, contact
the network administrator to check the company rules for IP and remote
connections.
Disable the Web browser proxy settings or make an exception to the proxy
rules to allow the protection relay's WHMI connection, for example, by
including the relay's IP address in Internet Options/Connections/LAN
Settings/Advanced/Exceptions.
For more information on the WHMI, see the operation manual.
4.7 Managing IED users
IED user authorization is disabled by default. IED user passwords can be changed in
LHMI, WHMI and using the IED Users tool in PCM600.
Local passwords can be changed only via the LHMI. Remote passwords
can be changed via the LHMI or WHMI or with PCM600.
1. Enable IED user authorization at Main Menu/Configuration/Authorization/
Passwords in LHMI or WHMI.
2. Use the IED Users tool in PCM600 to change the passwords.
This tool cannot be used to add or change users.
1MAC108982-MB E Section 4
Setting up a project
615 series ANSI 71
Engineering Manual
To Next Page
Loading...
