GUID-D0853D4E-D594-454A-9299-997ADF3E0896 V1 EN
Figure 44: Object properties
When communicating with the protection relay with PCM600 tools and with the
relay authentication enabled, the relay username and password must be given when
prompted. When setting the technical key, the username and password must be given
twice.
GUID-310E1587-D064-4823-9329-12163E0C9306 V1 EN
Figure 45: User login
If the PCM600 authentication has been enabled in PCM600 System
Settings, a relay user can be linked to the current PCM600 user by
selecting the Remember me check box in the Login dialog. After
that, the user credentials are no longer asked at tool communication
as logging in PCM600 also provides the authentication credentials
to the protection relay.
1MAC108982-MB E Section 4
Setting up a project
615 series ANSI 73
Engineering Manual
To Next Page
Loading...
