ABB Relion 615 series - LD0.UDFCNT1 Multipurpose Generic Up-Down Counter (1) - CTR-1; LD0.UDFCNT2 Multipurpose Generic Up-Down Counter (2) - CTR-2; LD0.UDFCNT3 Multipurpose Generic Up-Down Counter (3) - CTR-3; Unmapped Control Points

2.5.11 Unmapped control points
Table 191: Unmapped control points
IEC 61850 name
Description Value
LD0.LLN0.MeasStatRs.Oper.ctlVal Reset all min. and max. demands 1=Reset
LD0.LLN0.PQRs.Oper.ctlVal Reset all power quality data 1=Reset
LD0.FLTRFRC1.RcdRs.Oper.ctlVal Reset fault record data 1=Reset
2.5.12 Unmapped controls
2.5.12.1 LD0.UDFCNT1 Multipurpose generic up-down counter (1) – CTR-1
Table 192: LD0.UDFCNT1 Multipurpose generic up-down counter (1) – CTR-1
IEC 61850 name SA name Description Values
RsCnt.Oper.ctlVal Reset counter Resets counter value 0=Cancel; 1=Reset
LodCnt.Oper.ctlVal Load counter
Loads the counter to
preset value
0=Cancel; 1=Load
2.5.12.2 LD0.UDFCNT2 Multipurpose generic up-down counter (2) – CTR-2
Table 193: LD0.UDFCNT2 Multipurpose generic up-down counter (2) – CTR-2
IEC 61850 name
SA name Description Values
RsCnt.Oper.ctlVal Reset counter Resets counter value 0=Cancel; 1=Reset
LodCnt.Oper.ctlVal Load counter
Loads the counter to
preset value
0=Cancel; 1=Load
2.5.12.3 LD0.UDFCNT3 Multipurpose generic up-down counter (3) – CTR-3
Table 194: LD0.UDFCNT3 Multipurpose generic up-down counter (3) – CTR-3
IEC 61850 name
SA name Description Values
RsCnt.Oper.ctlVal Reset counter Resets counter value 0=Cancel; 1=Reset
LodCnt.Oper.ctlVal Load counter
Loads the counter to
preset value
0=Cancel; 1=Load
Section 2 1MAC252756-MB B
Modbus data mappings
106 REM615 ANSI
Point List Manual