ABB Relion 615 series - Page 13

LD0.SCA4GAPC3 Analog value scaling (3) – SCA4-3.................96
LD0.SCA4GAPC4 Analog value scaling (4) – SCA4-4.................97
LD0.SPEMMTR1 Single-phase power and energy
measurement (1).......................................................................... 97
LD0.SPEMMXU1 Single-phase power and energy
measurement demand values (1) – SP, SE-1.............................. 98
LD0.SPEMMXU1 Single-phase power and energy
measurement (1) – SP, SE-1......................................................100
Controls................................................................................................ 101
Reset, acknowledge and trigger points........................................... 101
CTRL.CBCSWI1 Circuit breaker control (1).................................... 102
CTRL.DCXSWI1 Disconnector control (1) – 29DS-1.......................102
CTRL.DCXSWI2 Disconnector control (2) – 29DS-2.......................103
CTRL.ESXSWI1 Grounding switch control (1) – 29GS-1................ 103
LD0.LDEV1 Protection relay's warm reset (1)................................. 103
LD0.SPCGAPC1 Generic control point (16 pcs) (1) – SPC-1......... 103
LD0.SPCGAPC2 Generic control point (16 pcs) (2) – SPC-2......... 104
LD0.SRGAPC1 Set-reset (8 pcs) (1) – SR-1...................................105
LD0.SRGAPC2 Set-reset (8 pcs) (2) – SR-2...................................105
Unmapped control points.................................................................106
Unmapped controls......................................................................... 106
LD0.UDFCNT1 Multipurpose generic up-down counter (1) –
CTR-1......................................................................................... 106
LD0.UDFCNT2 Multipurpose generic up-down counter (2) –
CTR-2......................................................................................... 106
LD0.UDFCNT3 Multipurpose generic up-down counter (3) –
CTR-3......................................................................................... 106
LD0.UDFCNT4 Multipurpose generic up-down counter (4) –
CTR-4......................................................................................... 107
Section 3 Glossary............................................................................ 109
Table of contents
REM615 ANSI 7
Point List Manual