ABB Relion 615 series - LD0.LEDGGIO1 Indication LED States Off;Colorx - LED

BitA RegA IEC 61850 name SA name Description Values
3526 220.06 .LEDSt7.stVal - LED 7 state 0/1=Color1/2
3527 220.07 .LEDSt8.stVal - LED 8 state 0/1=Color1/2
3528 220.08 .LEDSt9.stVal - LED 9 state 0/1=Color1/2
3529 220.09 .LEDSt10.stVal - LED 10 state 0/1=Color1/2
3530 220.10 .LEDSt11.stVal - LED 11 state 0/1=Color1/2
3531 220.11 <reserved> 0
2.3.1.38 LD0.LEDGGIO1 Indication LED states OFF/ColorX – LED
These LED indication points interpret the case when an indication signal is wired to either
the OK or ALARM input of the LED function block. The default color for ALARM is red
and green for OK. Colors can, however, be reconfigured with a setting parameter.
OK
ALARM
RESET
LEDx
OK
ALARM
RESET
LEDx
Signal
Signal
GUID-775477F8-C2DE-4138-B2C0-6B7C2774D4D2 V1 EN
Figure 4: Signal wired to either OK or Alarm input
Table 41: LD0.LEDGGIO1 Indication LED states OFF/ColorX – LED
BitA
RegA IEC 61850 name SA name Description Values
LD0.LEDGGIO1
2768 173.00 .LEDSt1.stVal - LED 1 state 0/1=Off/Color
2769 173.01 .LEDSt2.stVal - LED 2 state 0/1=Off/Color
2770 173.02 .LEDSt3.stVal - LED 3 state 0/1=Off/Color
2771 173.03 .LEDSt4.stVal - LED 4 state 0/1=Off/Color
2772 173.04 .LEDSt5.stVal - LED 5 state 0/1=Off/Color
2773 173.05 .LEDSt6.stVal - LED 6 state 0/1=Off/Color
Table continues on next page
Section 2 1MAC252756-MB B
Modbus data mappings
34 REM615 ANSI
Point List Manual