ABB Relion 615 series - LD0.UDFCNT4 Multipurpose Generic Up-Down Counter (4) - CTR-4; Registers; Active Parameter Setting Group - Read and Write; Premapped Registers

2.3.2.31 LD0.UDFCNT4 Multipurpose generic up-down counter (4) – CTR-4
Table 122: LD0.UDFCNT4 Multipurpose generic up-down counter (4) – CTR-4
BitA
RegA IEC 61850 name SA name Description Values
LD0. UDFCNT4
.DnCntSt.stVal DNCNT_STS Status of the down counting 1= down counting
.mcd
UpCntSt.stVal UPCNT_STS Status of the up counting 1= up counting
.mcd
2.4 Registers
Table 123: Explanations of columns in register tables
Column name Description
RegA Default 3X and 4X register address for the data.
Type Type of the register. The alternatives are u16, u32 (unsigned 16 and 32 bits integer) or
i16, i32 (signed 16 and 32 bit integer).
Scale Scale factor as default. Also, an adjustable offset value exists that is set to 0 by default.
IEC 61850 name Original IED data object identification. Described in the IEC 61850 format as Logical
Device.Logical Node and thereafter .Data Object.Data Attribute. Logical Node is the
same as the application function block name.
SA name
The signal may have a defined label that is visible, for example, in the Application
Configuration tool in PCM600.
Description Short description of the signal. See the technical manual for more information. Also, if a
register is writable, it is stated here.
Values The value range of the original IEC 61850 value, that is, before scaling.
2.4.1 Premapped registers
2.4.1.1 Active parameter setting group - read and write
Table 124: Active parameter setting group - read and write
RegA
Type Scale IEC 61850 name SA name Description Values
2301 u16 1 Active setting group 1...6
Section 2 1MAC252756-MB B
Modbus data mappings
68 REM615 ANSI
Point List Manual