GUID-B5A98F9F-E10D-4F92-A1ED-73D9B7719916 V1 EN
Figure 26: Installation plates for replacing SP_J40 relay
1 Installation plate
2 Torx head screw M5x10
3. Tighten the screws.
4. Mount the new IED.
For ordering numbers, see the ordering number table.
4.3.11 Replacing two Strömberg SP_J3 series relays by a 615
series IED
1. Make a new panel cut-out to the existing mounting panel according to the
dimensional drawing.
1MRS756375 K Section 4
Mounting
615 series 39
Installation Manual
To Next Page
Loading...
