Before connecting the auxiliary power, check that the terminal strip is wired and
placed correctly. Remove the protective film from the top side of the unit. Check
that there is no debris visible in the ventilation holes.
GUID-97A2D4BA-29FC-4E2F-8C4D-81EE5E77CF79 V1 EN
Figure 53: Removing the protective film
During the start-up all LEDs are lit for a short period.
• Green Ready LED starts to flash
• LCD lights up and IED start-up is displayed
• The main menu is displayed. A steady green Ready LED indicates a successful
start-up.
If the IED detects a diagnostic error during start-up, the green Ready LED flashes
and the internal fault code is displayed on the LCD.
Section 5 1MRS756375 K
Connecting
62 615 series
Installation Manual
To Next Page
Loading...
