6.3 Removing the IED
1. Turn off the power.
2. Detach the plug-in unit from the case.
3. Disconnect the wiring.
4. Loosen the four M5 fixing screws.
A070582 V4 EN
5. Detach the case from the panel cut-out.
6.4 Sending the IED for repair
In case of product problems, contact the nearest ABB office or representative for
consultation and instructions.
6.5 Exchanging the IED
To exchange the IED with another identical unit, remove the IED and install the
new one. The exchangeable units can be found from the PartsOnLine system, see
www.abb.com/partsonline. Use of PartsOnLine requires user registration.
To exchange an IED to a different unit, change the case and connect the wires.
Section 6 1MRS756375 K
Removing, repairing and exchanging
64 615 series
Installation Manual
To Next Page
Loading...
