ABB Relion 615 series - Controls; CTRL.CBCSWI1 Circuit Breaker (1) Control; Reset, Acknowledge and Trigger Points (B)

2.3.3 Controls
Table 122: Explanations of the controls table columns
Column name Description
IEC 61850
name
Original IED data object identification. Described in the IEC 61850 format as
Logical Device.Logical Node and thereafter .Data Object.Data Attribute. Logical
Node is the same as the application function block name.
SA name The signal may have a defined label that is visible for example in ACT.
Description Short description of the signal. See the application function block documentation
for more details.
Value Meaning of the written value.
2.3.3.1 CTRL.CBCSWI1 Circuit breaker (1) control
Table 123: CTRL.CBCSWI1 Circuit breaker (1) control
0xA CS IEC 61580 name SA name Description Values
CTRL.CBCSWI1
2048 1.00 .Pos.Oper.ctlVal Select open 1=Select
2049 1.01 .Pos.Oper.ctlVal Select close 1=Select
2050 1.02 .Pos.Oper.ctlVal Cancel selection 1=Cancel
2051 1.03 .Pos.Oper.ctlVal Execute selection 1=Execute
2052 1.04 .Pos.Oper.ctlVal Direct open 1=Open
2053 1.05 .Pos.Oper.ctlVal Direct close 1=Close
2.3.3.2 Reset, acknowledge and trigger points (B)
Table 124: Reset, acknowledge and trigger points (B)
0xA
CS IEC 61580 name SA name Description Values
LD0.LLN0
2060 2.00 .LEDRs1.Oper.ctlVal Reset indications and LEDs 1=Reset
2061 2.01 .LEDRs2.Oper.ctlVal Reset alarm LEDs 1=Reset
LD0.PEMSTA1
2062 2.02 .RecRs.Oper.ctlVal Reset power max demands 1=Reset
2063 2.03 < reserved >
2064 2.04 < reserved >
LD0.SSCBR1
2065 2.05 .RsAccAPwr.Oper.ctlVal Reset CB accum. energy 1=Reset
2066 2.06 .RsCBWear.Oper.ctlVal Reset CB wear data 1=Reset
DR.RDRE1
2067 2.07 .RcdTrg.Oper.ctlVal Trig DR recording 1=Trig
2068 2.08 .MemClr.Oper.ctlVal Clear DR memory 1=Clear
Table continues on next page
1MRS757057 B Section 2
Modbus data mappings
REU615 65
Point List Manual