The corresponding parameter values are "On" and "Off".
• IED input/output messages and monitored data names are shown in Courier
font, for example:
When the function starts, the START output is set to TRUE.
1.4.3 Functions, codes and symbols
Table 1: REF615 Functions, codes and symbols
Function IEC 61850 IEC 60617 IEC-ANSI
Protection
Three-phase non-directional
overcurrent protection, low stage,
instance 1
PHLPTOC1 3I> (1) 51P-1 (1)
Three-phase non-directional
overcurrent protection, high stage,
instance 1
PHHPTOC1 3I>> (1) 51P-2 (1)
Three-phase non-directional
overcurrent protection, high stage,
instance 2
PHHPTOC2 3I>> (2) 51P-2 (2)
Three-phase non-directional
overcurrent protection, instantaneous
stage, instance 1
PHIPTOC1 3I>>> (1) 50P/51P (1)
Three-phase directional overcurrent
protection, low stage, instance 1
DPHLPDOC1 3I> -> (1) 67-1 (1)
Three-phase directional overcurrent
protection, low stage, instance 2
DPHLPDOC2 3I> -> (2) 67-1 (2)
Three-phase directional overcurrent
protection, high stage
DPHHPDOC1 3I>> -> 67-2
Non-directional earth-fault protection,
low stage, instance 1
EFLPTOC1 Io> (1) 51N-1 (1)
Non-directional earth-fault protection,
low stage, instance 2
EFLPTOC2 Io> (2) 51N-1 (2)
Non-directional earth-fault protection,
high stage, instance 1
EFHPTOC1 Io>> (1) 51N-2 (1)
Non-directional earth-fault protection,
instantaneous stage
EFIPTOC1 Io>>> 50N/51N
Directional earth-fault protection, low
stage, instance 1
DEFLPDEF1 Io> -> (1) 67N-1 (1)
Directional earth-fault protection, low
stage, instance 2
DEFLPDEF2 Io> -> (2) 67N-1 (2)
Directional earth-fault protection, high
stage
DEFHPDEF1 Io>> -> 67N-2
Admittance based earth-fault
protection, instance 1
EFPADM1 Yo> -> (1) 21YN (1)
Admittance based earth-fault
protection, instance 2
EFPADM2 Yo> -> (2) 21YN (2)
Admittance based earth-fault
protection, instance 3
EFPADM3 Yo> -> (3) 21YN (3)
Table continues on next page
1MRS756712 C Section 1
Introduction
REF615 7
Point List Manual
To Next Page
Loading...
