ABB Relion 615 series - Activating Programmable Leds; Setting Autoscroll Delay

A070922-ANSI V2 EN
Figure 78: Editing the setting group value
The active setting group is indicated with an asterisk * .
Switching the Operation parameter of a function block on or off restarts
all control and protection functions.
6.4.2 Activating programmable LEDs
1. Select Main menu/Configuration/Programmable LEDs.
2.
Select a programmable LED with or .
3.
Press to enter the selection and to change the programmable LED mode.
4.
Change the mode with or and press to confirm the selection.
See the technical manual for details on LED configuration.
6.4.3 Setting autoscroll delay
Autoscroll delay parameter sets the delay of scrolling down measurements view if it is set
as default view and the user is logged out. Autoscroll is active if the delay value is not zero.
Section 6 1MAC054853-MB B
Operating procedures
106 615 series ANSI
Operation Manual