8.4.3 Setting the local HMI
8.4.3.1 Changing the local HMI language
1.
Select Main menu/Language and press .
2.
Change the language using or .
3.
Press to confirm the selection.
4. Commit the changes.
A071010 V2 EN
Figure 86: Changing the LHMI language
To change the language using a shortcut, press
and simultaneously
anywhere in the menu.
8.4.3.2 Adjusting the display contrast
Adjust the display contrast anywhere in the menu structure to obtain optimal readability.
•
To increase the contrast, press simultaneously and .
•
To decrease the contrast, press simultaneously and .
The selected contrast value is stored in the non-volatile memory if you are logged in and
authorized to control the protection relay. After an auxiliary power failure, the contrast is
restored.
Section 8 1MAC054853-MB B
Commissioning
136 615 series ANSI
Operation Manual
To Next Page
Loading...
