ABB Relion 615 series - Clearing and Acknowledging

A070932-ANSI V2 EN
Figure 42: Committing changes
Committing values takes a few seconds.
If the values are not committed, they are not taken into use and they are lost
after a reboot.
4.2.9 Clearing and acknowledging
All messages and indications, including LEDs and latched outputs as well as registers and
recordings, can be reset, acknowledged or cleared using the Clear menu.
1. Click Clear in the left navigation bar.
1MAC054853-MB B Section 4
Using the HMI
615 series ANSI 67
Operation Manual