ABB Relion 620 Series - Page 14

Section 1 1MAC308145-MB E
Introduction
8 RER620
Application Manual
Cold load timer 2 Phase A (in minutes) TPMGAPC1 TPM(1) 62CLD-2
Cold load timer 1 Phase B (in seconds) TPSGAPC2 TPS(2) 62CLD-3
Cold load timer 2 Phase B (in minutes) TPMGAPC2 TPM(2) 62CLD-4
Cold load timer 1 Phase C (in seconds) TPSGAPC3 TPS(3) 62CLD-5
Cold load timer 2 Phase C (in minutes) TPMGAPC3 TPM(3) 62CLD-6
Voltage Protection
Single-phase overvoltage 1, source 1 low stage SPHPTOV1 3U >(1) 59-1
Single-phase overvoltage 2, source 1 high stage SPHPTOV2 3U >(2) 59-2
Single-phase overvoltage 3, source 2 low stage SPHPTOV3 3U >(3) 59-3
Single-phase undervoltage 1, source 1 low stage SPHPTUV1 3U <(1) 27-1
Single-phase undervoltage 2, source 1 high stage SPHPTUV2 3U <(2) 27-2
Single-phase undervoltage 3, source 2 low stage SPHPTUV3 3U <(3) 27-3
Positive sequence overvoltage protection, source1 PSPTOV1 U1>(1) 59PS-1
Positive sequence overvoltage protection, source 2 PSPTOV2 U1>(2) 59PS-2
Negative sequence overvoltage protection, source1 NSPTOV1 U2>(1) 47
Negative sequence overvoltage protection, source 2 NSPTOV2 U2>(2) 47-2
Zero sequence overvoltage protection, source1 ROVPTOV1 Uo>(1) 59N-1
Zero sequence overvoltage protection, source 2 ROVPTOV2 Uo>(2) 59N-2
Frequency Protection
Underfrequency, Overfrequency, Frequency rate of change, Source 1, Stage 1 FRPFRQ1 f</f>,df/dt(1) 81-1
Underfrequency, Overfrequency, Frequency rate of change, Source 1, Stage 2 FRPFRQ2 f</f>,df/dt(2) 81-2
Load Shed & Restoration, Source 1, Stage 1 LSHDPFRQ1 UFLS/R(1) 81S-1
Load Shed & Restoration, Source 1, Stage 2 LSHDPFRQ2 UFLS/R(2) 81S-2
Other Protection
High Impedance Fault Detector PHIZ1 PHIZ1 HIZ
Circuit breaker failure protection SCCBRBRF1 3I>/Io>BF 50BFT
Circuit breaker close failure protection SCCBRBCF1 SCCBRBCF1 50BFC
Directional positive sequence power protection DPSRDIR1 P>-> 32P
Directional negative/zero sequence power protection DNZSRDIR1 Q>-> 32N
Control
Autoreclosing, 1ph and/or 3ph SDARREC1 O -> I 79
Synch-check/voltage check (Source 1 is defined as bus, Source 2 as line)
SECRSYN1 SYNC 25
Circuit Breaker 1 (3 state inputs / 3 control outputs) SCBXCBR1 I<->O CB 52
Loop control DLCM LCM LCM
Supervision and Monitoring
CB condition monitoring SPSCBR1 CBCM 52CM
Fuse failure supervision, Source 1 SEQRFUF1 FUSEF 60
Measurement
Three-phase current CMMXU1 3I IA,IB,IC
Demand metering, Max/Min metering CMSTA1
Sequence current CSMSQI1 I1,I2,I0 I1, I2, I0
Function IEC61850 IEC60617 ANSI/C37.2