A071224 V1 EN
Figure 80: Obtaining IP address automatically
5. Close all open windows by clicking OK and start PCM600.
Administrator rights are requested to change the configuration as
described above.
Setting the rear communication
To set up a standard PC with MicroSoft Windows operating system for rear
communication:
1. To open Network Connections, click Start, point to Settings, click Control Panel,
and then double-click Network Connections.
2. Double-click the connection that you want to configure, and then click Properties.
3. Select the TCP/IP protocol from the list of configured components using this
connection and click Properties.
Section 8 1MAC456939-IB D
Commissioning
118 620 series ANSI
Operation Manual
To Next Page
Loading...
