ABB RELION 670 SERIES REG670 - Page 692

Setting Short Description Selected
value
Comments
PHiHiLim High High limit (physical value),
% of SBase
60 High alarm limit that is, extreme
overload alarm, hence it will be 415
MW.
PHiLim High limit (physical value), in %
of SBase
50 High warning limit that is, overload
warning, hence it will be 371 MW.
PLowLim Low limit (physical value), in % of
SBase
-50 Low warning limit -500 MW
PLowLowlLim Low Low limit (physical value), in
% of SBase
-60 Low alarm limit -600 MW
PLimHyst Hysteresis value in % of range
(common for all limits)
1 Set ±Δ Hysteresis 20 MW that is, 1%
of range (2000 MW)
Table 67: Settings for calibration parameters
Setting Short Description Selected
value
Comments
IMagComp5 Magnitude factor to calibrate
current at 5% of In
0.00
IMagComp30 Magnitude factor to calibrate
current at 30% of In
0.00
IMagComp100 Magnitude factor to calibrate
current at 100% of In
0.00
VAmpComp5 Magnitude factor to calibrate
voltage at 5% of Vn
0.00
VMagComp30 Magnitude factor to calibrate
voltage at 30% of Vn
0.00
VMagComp100 Magnitude factor to calibrate
voltage at 100% of Vn
0.00
IAngComp5 Angle calibration for current at
5% of In
0.00
IAngComp30 Angle pre-calibration for current
at 30% of In
0.00
IAngComp100 Angle pre-calibration for current
at 100% of In
0.00
Measurement function application for a power transformer
SEMOD54481-61 v9
Single line diagram for this application is given in figure 310.
Section 17 1MRK 502 071-UUS A
Monitoring
686 Generator protection REG670 2.2 ANSI and Injection equipment REX060, REX061, REX062
Application manual