Table 37. Line differential protection L3CPDIF, L6CPDIF, LT3CPDIF , LT6CPDIF with 2 Mbits/s communication , continued
Function Range or value Accuracy
**Operate time, unrestrained negative
sequence function
Min. = 10 ms
Max. = 25 ms
-
**Reset time, unrestrained negative
sequence function
Min. = 10 ms
Max. = 30 ms
-
The data in the table are valid for a single IED with 2 Mbits/s communication in loop-back mode.
*Note: Data obtained with single three-phase input current group.
**Note: Data obtained with two three-phase input current groups. The rated symmetrical currents are applied on both sides as pre- and
post-fault currents. The fault is performed by increasing one phase current to double on one side and decreasing same phase current to
zero on the other side.
Line differential protection RED670
1MRK 505 379-BEN N
Hitachi Power Grids 81
© Copyright 2017 Hitachi Power Grids. All rights reserved
To Next Page
Loading...
