IEC16000170 V1 EN-US
Figure 80: PCM600: GOOSE option in ACT
The “Connect to GOOSE dialog” window opens, for detailed information on
the “Connect to GOOSE dialog” window refer to Section "User interface".
2. Under Select sender IEDs section, check sender IEDs that can be received on
receiver signal.
3. Under Sender IEDs section, select needed data attribute in Application
configuration tab (see Figure
75) and click on the “Connect” button.
GOOSE connection will be added as shown in the Figure 81 below.
IEC16000174 V1 EN-US
Figure 81: ACT: GOOSE configuration on Receiver IED (left) and
Sender IED (right) side
4. If SCL configuration data attributes needs to be connected , the needed data
attribute shall be selected in the SCL configuration tab (see Figure 76). Click
on the “Connect” button.
1MRK 511 398-UEN C Section 8
IEC 61850 communication engineering
670 series 2.2 IEC 121
Engineering manual
To Next Page
Loading...
