• Organizing the bay IEDs in the structure of the substation by defining
voltage levels and bays below the substation. A PCM600 project can
have only one substation.
• Configuring Ethernet ports, Routes and Merging units using the Ethernet
configuration tool.
• Configuring the IED functions (for example protection and control
functions and LHMI functions) by using the Application Configuration
tool.
• Configuring the parameters and setting values for the IED itself and for
the process functionality by using the Parameter Setting tool.
• Drawing single line diagrams and do the link to dynamic process values
by using the Graphical Display Editor tool. The single line diagrams are
shown on the LHMI on the bay IED.
• Configuring connections between the application configuration function
blocks and physical hardware input and outputs by using the Signal
Matrix tool or the Application Configuration tool.
• Communication engineering
• IEC 61850 station communication engineering can be done in two ways,
with a separate tool, IET600 or with the PCM600 built in IEC 61850
configuration tool. PCM600 interacts with IET600 by importing and
exporting SCL files. The built in tool can be used for small projects
including ABB IEDs only. To engineer communication between ABB
IED's and third party devices it's recommended to use IET600.
• Organizing GOOSE messages received is done by using the Signal
Matrix tool.
• Communication engineering for the DNP3 protocol by using the
Communication Management tool.
• Disturbance record management
• Generating overviews about the available (disturbance) recordings in all
connected protection IEDs by using the Disturbance Handling tool.
• Manually reading the recording files (in COMTRADE format) from the
IEDs by using the Disturbance Handling tool or automatically by using
the PCM600 scheduler.
• Managing recording files with the assistance of the Disturbance
Handling tool.
• Creating overview reports of recording file content for fast evaluation
with assistance of the Disturbance Handling tool.
• Service management
• Monitoring selected signals of an IED for commissioning or service
purposes by using the Signal Monitoring tool.
• Listing all actual existing IED internal events by using the Event Viewer
tool.
• Listing all actual pending process events as they are stored in the IED
internal disturbance report event list by using the Event Viewer tool.
1MRK 511 398-UEN C Section 2
Engineering tool set
670 series 2.2 IEC 25
Engineering manual
To Next Page
Loading...
