Section 3 Engineering process
3.1 Workflow
SEMOD58465-5 v13
IEC08000122-6-en.vsd
Make GOOSE connections
Export SCL files, IED-level
CID files, etc. from PCM600
Import SCL files to IET600
and do signal engineering.
Export SCL files from
IET600.
Import SCL files, IED-level
CID files, etc. to PCM600
Write configuration
to IED
Start
HWT
ACT/
SMT
PST
GDE
CMT
ACT
Export
IED
WRITE
IET600
Import
IED
WRITE
EndEnd
Optional, can be used to add
additional hardware modules
Configure IED functionality
Parametrization
Signal engineering
Create Single line diagram
for local HMI
Save the work
between the
different steps
Project
Create plant structure
Write configuration
to IED
IEC 61850
Supported
protocols
IEC 61850
configuration
tool
SMT
FPN
ECT
Configure Ethernet ports,
Routes and Merging units
ACT
Easy GOOSE
engineering
IEC08000122 V6 EN-US
Figure 4: IED engineering workflow
The described sequence in Figure 4 is a proposal based on practical experience and
dependencies of the steps. It is possible to do a different sequence based on the
available information at the time the project is started. This means that several
iterations may be needed to finish the project.
• Setting up the PCM600 project
1MRK 511 398-UEN C Section 3
Engineering process
670 series 2.2 IEC 29
Engineering manual
To Next Page
Loading...
