During a write both the basic and advanced settings are written to
the IED.
6.2.1 Graphical Parameter Setting Tool
GUID-C726930D-D55E-4426-A14F-F4E6C7F6131C v2
The Graphical Parameter Setting tool (GPST) is a tool in PCM600 that is used to
present parameter settings in a graphical user interface. GPST is a part of the
Parameter Setting tool (PST), the settings are done in PST and can be presented in
GPST.
GPST is available for distance protection functions:
Under impedance protection for generators and transformers ZGTPDIS
Distance protection, quadrilateral characteristic ZRWPDIS
Distance protection zone, quadrilateral characteristic ZMQPDIS, ZMQAPDIS
Distance measuring zone, quadrilateral characteristic for series
compensated lines
ZMCPDIS, ZMCAPDIS
Fullscheme distance protection, mho characteristic ZMHPDIS
Fullscheme distance protection, quadrilateral for earth faults ZMMPDIS, ZMMAPDIS
Distance protection zone, quadrilateral characteristic, separate settings ZMRPDIS, ZMRAPDIS
High speed distance protection, quadrilateral and mho ZMFPDIS
High speed distance protection for series compensated lines, quadrilateral
and mho
ZMFCPDIS
Directional impedance element for mho characteristic ZDMRDIR
Directional impedance quadrilateral ZDRDIR
Directional impedance quadrilateral, including series compensation ZDSRDIR
Underimpedance protection for generators and transformers ZGVPDIS
Power swing detection ZMRPSB
Phase selection, quadrilateral characteristic with fixed angle FDPSPDIS
Phase selection, quadrilateral characteristic with settable angle FRPSPDIS
Faulty phase identification with load encroachment FMPSPDIS
For more information on GPST, see the online help for PCM600.
6.3 Connecting signals in SMT
GUID-B413A348-61AA-482E-AA4A-E351D3B2ED8F v5
SMT is used to connect the application to I/O, binary, and GOOSE, see Figure 43:
1MRK 511 398-UEN C Section 6
Protection and control engineering
670 series 2.2 IEC 79
Engineering manual
To Next Page
Loading...
