ABB Relion 670 series - Page 1124

PID-3781-MONITOREDDATA v3
Table 815: SP16GAPC Monitored data
Name Type Values (Range) Unit Description
OUT1 GROUP
SIGNAL
- - Output 1 status
OUT2 GROUP
SIGNAL
- - Output 2 status
OUT3 GROUP
SIGNAL
- - Output 3 status
OUT4 GROUP
SIGNAL
- - Output 4 status
OUT5 GROUP
SIGNAL
- - Output 5 status
OUT6 GROUP
SIGNAL
- - Output 6 status
OUT7 GROUP
SIGNAL
- - Output 7 status
OUT8 GROUP
SIGNAL
- - Output 8 status
OUT9 GROUP
SIGNAL
- - Output 9 status
OUT10 GROUP
SIGNAL
- - Output 10 status
OUT11 GROUP
SIGNAL
- - Output 11 status
OUT12 GROUP
SIGNAL
- - Output 12 status
OUT13 GROUP
SIGNAL
- - Output 13 status
OUT14 GROUP
SIGNAL
- - Output 14 status
OUT15 GROUP
SIGNAL
- - Output 15 status
OUT16 GROUP
SIGNAL
- - Output 16 status
OUTOR GROUP
SIGNAL
- - Output status logic OR gate for input 1 to
16
18.4.5.6 Operation principle
SEMOD55725-5 v6
Upon receiving a signal at its input, Generic communication function for Single Point indication
(SPGAPC) function sends the signal over IEC 61850-8-1 to the equipment or system that requests
this signal. To get the signal, PCM600 must be used to define which function block in which
equipment or system should receive this information.
18.4.6 Generic communication function for Measured Value MVGAPC
SEMOD55402-1 v3
Section 18 1MRK 502 066-UUS B
Station communication
1118
Technical manual