ABB Relion 670 series - Page 1262

21.3.2 Function block
SEMOD54888-4 v5
TESTMODE
IED_TEST TEST
IED_TEST
BLOCK
NOEVENT
INPUT
SETTING
IEC61850
IEC14000072-1-en.vsd
IEC09000219 V2 EN-US
Figure 634: TESTMODE function block
21.3.3 Signals
IP9680-1 v2
PID-3995-INPUTSIGNALS v2
Table 972: TESTMODE Input signals
Name Type Default Description
IED_TEST BOOLEAN 0 Activate IED test mode
PID-3995-OUTPUTSIGNALS v2
Table 973: TESTMODE Output signals
Name Type Description
TEST BOOLEAN In test via IED TEST or via LD0 Mode
IED_TEST BOOLEAN IED test mode is active
BLOCK BOOLEAN Active when LD0 is blocked or test blocked
NOEVENT BOOLEAN Event disabled during test mode
INPUT BOOLEAN IED TEST input is active
SETTING BOOLEAN IED test mode setting is On
IEC61850 BOOLEAN Active when LD0 Mode is in Blocked, Test or Test blocked
21.3.4 Settings
IP11343-1 v2
PID-6584-SETTINGS v4
Table 974: TESTMODE Non group settings (basic)
Name Values (Range) Unit Step Default Description
IEDTestMode Disabled
Enabled
- - Disabled Activate IED Test mode
EventDisable Disabled
Enabled
- - Disabled Event disable during test mode
BlockAllFunc Disabled
Enabled
- - Enabled Block all functions when entering IED test
mode
CmdTestEd1 Disabled
Enabled
- - Disabled Require test bit in command at test mode
(only for IEC61850 Ed1)
Section 21 1MRK 502 066-UUS B
Basic IED functions
1256
Technical manual