21.5.3 Factory defined settings
M11789-39 v10
The factory defined settings are very useful for identifying a specific version and very helpful in the
case of maintenance, repair, interchanging IEDs between different Substation Automation
Systems and upgrading. The factory made settings can not be changed by the customer. They can
only be viewed. The settings are found in the local HMI under Main menu/Diagnostics/IED status/
Product identifiers
The following identifiers are available:
• IEDProdType
• Describes the type of the IED. Example:
REL670
• ProductDef
• Describes the release number from the production. Example:
2.1.0
• FirmwareVer
• Describes the firmware version.
• The firmware version can be checked from Main menu/Diagnostics/IED status/Product
identifiers
• Firmware version numbers run independently from the release production numbers. For
every release number there can be one or more firmware versions depending on the
small issues corrected in between releases.
• ProductVer
• Describes the product version. Example:
2.1.0
1 is the Major version of the manufactured product this means, new platform of the product
2 is the Minor version of the manufactured product this means, new functions or new hardware
added to the product
3 is the Major revision of the manufactured product this means, functions or hardware is either
changed or enhanced in the product
• IEDMainFunType
• Main function type code according to IEC 60870-5-103. Example: 128 (meaning line
protection).
• SerialNo
• OrderingNo
• ProductionDate
21.6 Signal matrix for binary inputs SMBI
SEMOD55793-1 v2
21.6.1 Functionality
M15302-3 v5
The Signal matrix for binary inputs (SMBI) function is used within the Application Configuration
Tool (ACT) in direct relation with the Signal Matrix Tool (SMT), see the application manual to get
information about how binary inputs are brought in for one IED configuration.
1MRK 502 066-UUS B Section 21
Basic IED functions
1259
Technical manual
To Next Page
Loading...
