22.4.2 19” panel rack mounting
IP10313-1 v1
22.4.2.1 Overview
SEMOD127656-5 v4
All IED sizes can be mounted in a standard 19” cubicle rack by using a suitably sized mounting kit
consisting of two mounting angles, their fastening screws and washers.
The mounting angles are reversible which enables mounting of IED size 1/2 x 19” or 3/4 x 19” either
to the left or the right side of the cubicle.
A separately ordered rack mounting kit for side-by-side mounted IEDs or IEDs
together with RHGS cases should be selected so that the total size equals 19”.
Use only the screws included in the mounting kit when mounting the plates and the
angles on the IED. Screws with wrong dimension may damage the PCBs inside the
IED.
Section 22 1MRK 502 066-UUS B
IED hardware
1344
Technical manual
To Next Page
Loading...
