22.4.3 Wall mounting
IP10316-1 v1
22.4.3.1 Overview
M11973-3 v5
All case sizes, 1/2 x 19”, 3/4 x 19”,1/1 x 19”, can be wall mounted. It is also possible to mount the
IED on a panel or in a cubicle.
When mounting the side plates, use screws that follow the recommended
dimensions. Using screws with other dimensions may damage the PCBs inside the
IED.
If fiber cables are bent too much, the signal can be weakened. Wall mounting is
therefore not recommended for any communication modules with fiber
connection.
22.4.3.2 Mounting procedure for wall mounting
M11949-2 v2
IEC13000266-1-en.vsd
1
2
3
4
5
6
IEC13000266 V1 EN-US
Figure 684: Wall mounting details.
Section 22 1MRK 502 066-UUS B
IED hardware
1346
Technical manual
To Next Page
Loading...
