22.4.4 Side-by-side 19” rack mounting
IP10323-1 v1
22.4.4.1 Overview
M11974-3 v2
IED case size 1/2 x 19” or 3/4 x 19” and RHGS cases can be mounted side-by-side up to a maximum
size of 19”. For side-by-side rack mounting, the side-by-side mounting kit together with the 19”
rack panel mounting kit must be used. The mounting kit has to be ordered separately.
When mounting the plates and the angles on the IED, use screws that follow the
recommended dimensions. Using screws with other dimensions may damage the
PCBs inside the IED.
22.4.4.2 Mounting procedure for side-by-side rack mounting
M11955-2 v4
IEC04000456 V2 EN-US
Figure 686: Side-by-side rack mounting details.
The required torque for the screws is 3.5 Nm.
PosNo Description Quantity Type
1 Mounting plate 2 -
2, 3 Screw 16 M4x6
4 Mounting angle 2 -
5 Washer 16 M4x6
Section 22 1MRK 502 066-UUS B
IED hardware
1348
Technical manual
To Next Page
Loading...
