Please contact factory for special add on plates for mounting FT switches on the
side (for 1/2 19" case) or bottom of the relay.
22.4.5.2 Mounting procedure for side-by-side flush mounting
M12730-6 v4
IEC06000181 V2 EN-US
Figure 688: Side-by-side flush mounting details (RHGS6 side-by-side with 1/2 x 19” IED).
The required torque for the screws is 3.5 Nm.
PosNo Description Quantity Type
1 Mounting plate 2 -
2, 3 Screw, washer 16 M4x6
4 Mounting angle 2 -
Section 22 1MRK 502 066-UUS B
IED hardware
1350
Technical manual
To Next Page
Loading...
