15.7.7.1 Function block
GUID-C0490ECF-5C4E-4F17-B628-482694C590D2 v1
PULSETIMERQT
INPUT OUT
IEC15000145.vsd
IEC15000145 V1 EN-US
Figure 508: PULSETIMERQT function block
15.7.7.2 Signals
GUID-4543C4C9-FAE2-4328-8DE2-4A5756A020E9 v1
PID-3810-INPUTSIGNALS v4
Table 663: PULSETIMERQT Input signals
Name Type Default Description
INPUT BOOLEAN 0 Input signal
PID-3810-OUTPUTSIGNALS v4
Table 664: PULSETIMERQT Output signals
Name Type Description
OUT BOOLEAN Output signal
15.7.7.3 Settings
PID-3810-SETTINGS v4
Table 665: PULSETIMERQT Non group settings (basic)
Name Values (Range) Unit Step Default Description
t 0.000 -
90000.000
s 0.001 0.010 Pulse time length
15.7.7.4 Technical data
GUID-61263951-53A8-4113-82B5-3DB3BF0D9449 v1
Table 666: Number of PULSETIMERQT instances
Logic block Quantity with cycle time Range or Value Accuracy
3 ms 8 ms 100 ms
PULSETIMERQT - 10 30
(0.000–90000.000) s ±0.5% ±10 ms
15.7.8 Reset/Set function block RSMEMORYQT
GUID-095B2670-610E-47AE-A5D3-F3E7C0A56B65 v2
GUID-32A1B759-2ED8-45B3-8385-762167626CE2 v4
The Reset-set function (RSMEMORYQT) is a flip-flop with memory that can reset or set an output
from two inputs respectively. Each RSMEMORYQT function block has two outputs, where one is
inverted. The memory setting controls if, after a power interruption, the flip-flop resets or returns
to the state it had before the power interruption. For a Reset-Set flip-flop, the RESET input has
higher priority than the SET input.
Section 15 1MRK 502 066-UUS B
Logic
976
Technical manual
To Next Page
Loading...
