It is also possible to insert an IED from the template library to create a new IED in the
plant structure. After a template IED has been imported, the IP address, the Caption
in IED's Object Properties and the Technical Key that corresponds to the physical
IED have to be changed.
A template IED can be inserted only when the bay is selected in the
plant structure.
1. In the Plant structure view, select the bay, right-click, point to New and select
Create from template.
The Create New Object from Template dialog box opens.
GUID-A5D22ADA-02A5-43F8-BA02-52A4A915D7EA V2 EN
Figure 29: PCM600: Selecting an IED from the template library
2. Select the IED from the list of available IEDs.
3. Click the icon on the right column in the list of available templates.
The Template Properties dialog box opens.
Section 4 1MRS757810 C
Setting up a project
52 REC615 and RER615
Engineering Manual
To Next Page
Loading...
