ABB RELION REM615 - Mounting Methods

Table 73. Large display
Character size
1)
Rows in the view Characters per row
Small, mono-spaced (6x12 pixels) 10 20
Large, variable width (13x14 pixels) 8 8 or more
1) Depending on the selected language
21. Mounting methods
By means of appropriate mounting
accessories the standard IED case for the 615
series IED can be flush mounted, semi-flush
mounted or wall mounted. The flush
mounted and wall mounted IED cases can
also be mounted in a tilted position (25°)
using special accessories.
Further, the IEDs can be mounted in any
standard 19” instrument cabinet by means of
19” mounting panels available with cut-outs
for one or two IEDs. Alternatively, the IED
can be mounted in 19” instrument cabinets
by means of 4U Combiflex equipment frames.
For the routine testing purposes, the IED
cases can be equipped with test switches,
type RTXP 18, which can be mounted side by
side with the IED cases.
Mounting methods:
• Flush mounting
• Semi-flush mounting
• Semi-flush mounting in a 25° tilt
• Rack mounting
• Wall mounting
• Mounting to a 19" equipment frame
• Mounting with a RTXP 18 test switch to a
19" rack
Panel cut-out for flush mounting:
• Height: 161.5±1 mm
• Width: 165.5±1 mm
4
8
1
53
1
7
7
17 7
16 0
IECA070900 V3 EN
Figure 9. Flush mounting
1
0
3
9
8
1
8
6
160
1
7
7
IECA070903 V3 EN
Figure 10. Semi-flush
mounting
1
3
3
1
0
7
23 0
2
5
°
1
9
0
IECA070902 V3 EN
Figure 11. Semi-flush with a
25º tilt
Motor Protection and Control 1MRS756890 D
REM615
Product version: 3.0 Issued: 2010-06-29
ABB 53