Choosing between the two ways depends on when the IP address is set. Typing the IP
address via the IED's Object Properties pane is possible at any time while entering it
via the configuration wizard can only be done when inserting the IED in online or
offline mode.
GUID-1DB6FC9A-A5E6-4E63-BE24-E8724F42F1E0 V1 EN
Figure 33: Alternative 1: Setting the IP address on the first wizard page
1. In the Plant Structure view, select the IED whose IP address must be entered.
2. On the View menu, select Object Properties.
3. In the Object Properties pane, type the IP address in the IP Address box.
GUID-055D3525-0E2E-45D2-9451-FF766F69C928 V1 EN
Figure 34: Alternative 2: Setting the IP address in the IED's Object
Properties pane
1MRS759117 A Section 4
Setting up a project
REX640 57
Engineering Manual
To Next Page
Loading...
