The WARNING output in the receiver is activated if the synchronization accuracy of
the sender or the receiver is worse than 4 μs. The output is held on for 10 seconds after
the synchronization accuracy returns within limits.
The WARNING output is always internally active whenever the ALARM output is
active.
3.13.4.4 Signals
Table 49: RESTVTR Input signals
Name Type Default Description
Uo INT32-UL0 0 IEC61850-9-2 residual
voltage
Table 50: RESTVTR Output signals
Name Type Description
ALARM BOOLEAN Alarm
WARNING BOOLEAN Warning
3.13.4.5 Settings
Table 51: RESTVTR Non group settings (Basic)
Parameter
Values (Range) Unit Step Default Description
Primary voltage 0.100...440.000 kV 0.001 11.547 Primary voltage
Secondary voltage 60...210 V 1 100 Secondary voltage
Amplitude Corr 0.9000...1.1000 0.0001 1.0000 Amplitude correction
Angle correction -20.0000...20.0000 deg 0.0001 0.0000 Angle correction factor
3.13.4.6 Monitored data
Monitored data is available in three locations.
• Monitoring/I/O status/Analog inputs
• Monitoring/IED status/SMV traffic
• Monitoring/IED status/SMV accuracy
3.14 GOOSE function blocks
GOOSE function blocks are used for connecting incoming GOOSE data to
application. They support BOOLEAN, Dbpos, Enum, FLOAT32, INT8 and INT32
data types.
Section 3 1MRS758755 A
Basic functions
106 REC615 and RER615
Technical Manual
To Next Page
Loading...
