ABB REM630 - Input;Output Signal Interfaces

Functions IEC 61850 IEC ANSI
Tripping logic TRPPTRC1 I→O 94
Three phase current
measurement, instance 1
CMMXU1 (1) 3I (1) 3I (1)
Three phase voltage
measurement, phase-to-phase
(RMS)
VPPMMXU1 3Upp 3Upp
Sequence current measurement CSMSQI1 I
1
, I
2
I
1
, I
2
Sequence voltage measurement VSMSQI1 U
1
, U
2
V
1
, V
2
Power monitoring with P, Q, S,
power factor, frequency
PWRMMXU PQf PQf
Energy monitoring EPDMMTR E E
Analog channels 1-10 (samples) A1RADR ACH1 ACH1
Binary channels 1-16 B1RBDR BCH1 BCH1
Binary channels 17 -32 B2RBDR BCH2 BCH2
Binary channels 33 -48 B3RBDR BCH3 BCH3
Binary channels 49 -64 B4RBDR BCH4 BCH4
3.2.3 Input/output signal interfaces
Table 7: Interface of binary inputs
Hardware module instance
Hardware channel Description
COM BI1 Circuit breaker close
COM BI2 Circuit breaker open
COM BI3 Circuit breaker truck in
COM BI4 Circuit breaker truck out
COM BI5 Earth switch close
COM BI6 Earth switch open
COM BI7 External restart inhibit
COM BI8 Speed switch
COM BI9 External trip
COM BI10 Lockout reset
COM BI11 Allow emergency start
COM BI12 Circuit breaker gas pressure
COM BI13 Circuit breaker spring charged
COM BI14 MCB open
The outputs of the IED are categorized as power outputs (POx) and signal outputs
(SOx). The power outputs can be used for starting and stopping the motor. The
signal outputs are not heavy-duty outputs. They are used for alarm or signaling
purposes.
Section 3 1MRS756785 A
REM630 variants
26 REM630
Application Manual