ABB S800 I/O - DO801;DO802;DO810;DO814;DO815;DO818;DO820;DO821;DO828 Module Details

*HQHUDO,QIRUPDWLRQDQG,QVWDOODWLRQ8VHU¶V*XLGH
6HFWLRQ$ 7%0RGXOH%XV0RGHP
3BSE 020 923R101 121
$ 7%0 RGXOH%XV0RGHP
)HDWXUHV
• 2 fiber optic ports to optical ModuleBus
• ModuleBus (electrical) to the I/O Modules
• Supervisory functions of I/O ModuleBus and power supply
• Isolated power supply to I/O modules
• DIN rail mounting.
'HV FULSWLRQ
The TB820 ModuleBus Modem is a communication interface for
connection of S800 I/O modules via the optical and electrical
ModuleBus.
The TB820 can be used in both a simplex optical configuration as
well as in a duplex optical configuration. In a simplex
configuration, the optical Modulebus nodes are connected in a ring.
In a duplex configuration, the optical Modulebus nodes are
connected in a row.
TB820 has two basic parts: Module termination board and the
power supply/communications board (see block diagram).
The termination board is a unit where most of the connections to
the outside takes place. It is grounded to the DIN-rail through a
metallic spring connector. The board carries screw terminals for power supply and redundant power
supply monitoring, connector for the electrical Modulebus, a current limit “fuse” for the +24V
supply of the I/O modules and the electrical Modulebus.
The power supply board has an isolated power converter that generates a short circuit proof +5V
supply for the TB820 and connected I/O modules. This board also contains the Modulebus
interfaces, LED indicators and one screwdriver maneuvered rotary switch for the Modulebus I/O
cluster address. The Modulebus I/O cluster address (1-7) is set by a rotary decimal code switch, any
other value than 1-7 is not allowed and will turn the Run LED off.
1
2
7
5
3
4
6
CLUSTER
SB
SA
L-
L+ L+
L-
FR
ORx2ORx1
P
TB820
ERx
X4
X5
Rx
Tx
Rx
Tx
X1B
X1A