ABB SACE PR010/T - Relay Data and Programming; Protection Parameters Display; Trip History Logging; General Relay Information

ABB SACE SACE PR010/T RH0025002 L2551 11/20
20
Ø or × keys and press “Enter”.
To return to the main menu, press “ESC”.
The moving sequence indicates that the test unit is busy, so you must wait until it has finished.
Sub-menu 1. "Operation mode" of the main menu is different for each type of protection unit (see
"Operation mode menu tree").
Sub-menus 2. "Report download", 3. "PR010/T Config." and 4. "SW updating" are the same for
all the protection units.
5.1.1 Report downloading
The SACE PR010/T test unit can download a test report onto a PC which contains all the
information indicated under the heading "Test report".
5.1.2 Test unit configuration
The test unit configuration can be customized.
You can define a password (Define password) to use to access the testing and programming
stages, to adjust brightness and contrast, and to select the language of your choice (default
password: 00000).
If, after specifying a new password, you want to restore the default setting, you need to zero the
password; to do so, select the "Reset password" item and notify ABB SACE of the code displayed
(e.g. CODE = 63795 ).
ABB SACE will provide an unlock code to input on the same page ( PLEASE INSERT RESET
CODE----- ) which enables you to reset the PR010/T with the default password (00000).
N.B. The unlock code can only be used for one password zeroing operation; for any subsequent
password zeroing operations, you must go to the "Reset password" page again and notify ABB
SACE of the new code it displays (e.g. CODE = 83922 ) in order to obtain the new unlock code.
You can also perform a test on the unit by selecting the "Test" menu.
The software is self-explanatory; simply follow the instructions that appear on the screen.
5.1.3 Software updating
The software installed on the SACE PR010/T test unit may be upgraded simply by connecting it
to a PC and following the procedure described below in the section "Communication with PC".
5.2 Communication with PC
Using the "SD-TU Interface" software provided it is possible to update the SACE PR010/T unit,
customizing the list of devices available for the test.
To install the software, just run the application "SD-TU Interface xxx.msi". The steps necessary
for updating the test unit software are listed below.