ABB ScreenMaster RVG200 - Mounting Dimensions and Panel Cutout

14
SCREENMASTER RVG200 / PAPERLESS RECORDER | CI/RVG200/001-EN REV. A
… 6 Basic setup
Change the channel configuration
1 At the System Configuration page, press the Channels icon
to display the I/O Groups 1(6) Channels page.
2 Press the icon associated with the required Group 1 (6)
Channels (for example ) to display the Channel 1 (01 …06)
dialog.
IMPORTANT (NOTE)
Use the arrows to select different
Channels in the same process group.
3 Press the
Setup
tab and then the icon associated with
each field to enter and configure Setup parameters – press
to accept the content at each field.
4 Repeat for all other tabs on the Channel 1.01 (1.06) dialog
and for all other required channels.
When all fields have been configured, press to return to
the I/O Groups 1(6) Channels page then to return to
the System Configuration page.
5 Proceed to the next section to set up the inputs / outputs
(I/O).
Set up the inputs / outputs (I/O)
1 At the System Configuration page, press the I/O icon to
open an I/O page displaying fitted I/O modules.
IMPORTANT (NOTE)
I/O modules are detected automatically.
2 Press the icon associated with the required module to
display the dialog and fields associated with that module.
3 Configure parameters for each required module.
4 When all parameters have been configured, press to
return to the I/O page then to return to the System
Configuration page.
5 Proceed to the next section to exit Configuration level and
save changes.
Save current configuration and exit
1 Press at the System Configuration page – a prompt is
displayed with options to Apply Changes, Export
Configuration, Return to Configuration Mode or Discard
Changes:
2 Press Apply Changes ( ) to save the current
configuration and return to the Operator page.
3 Proceed to the next section to start recording.
Start recording (archiving)
1 Open the media door and insert the external media card and
close the door.
Recording is initiated automatically.
IMPORTANT (NOTE)
Alternative archive media can be used – refer to
the Operating instructions (OI/RVG200-EN) for
compatible media types.
System Conguration
Apply Changes
Export Conguration
Return to Conguration Mode
Discard Changes