ABB STT04 - Page 108

EQS TEMPERATURE TRANSMITTER
CREATE/MODIFY CONFIGURATION
C - 3
Select LINEAR.
If FUNC GENERATOR is selected, specify 5 input
and output points between 0 and 100%.
Refer to the Platinum Standard Series Smart Tem-
perature Transmitter EQS instruction for descrip-
tion.
Enter a value between 0 and 32. Refer to the Plati-
num Standard Series Smart Temperature Trans-
mitter EQS instruction for description.
Enter the lower range temperature value and press
. Input the upper range value.
Select an initialization mode using the arrow keys.
Refer to the Platinum Standard Series Smart Tem-
perature Transmitter EQS instruction for descrip-
tion.
Select a fail mode using the arrow keys.
Refer to the Platinum Standard Series Smart Tem-
perature Transmitter EQS instruction for descrip-
tion.
Enter up to 6 characters. Use familiar units to
describe the output.
To select a character, press the key that has the
desired character. Continue to press the key until the
desired character appears. Use the right arrow key to
move to the next character. Use the left arrow key to
go back to the previous character. Press
when finished.
Input the lower range value and press .
Input the upper range value.
Key Display Comments
ENTER
OUTPUT TYPE:
→ LINEAR
FUNC GENERATOR
ENTER
OUTPUT ACTION:
→ NORMAL
REVERSE
ENTER
DAMPING:
(0-32 SEC)
nn.nn SECS
ENTER
LOWER RANGE VAL
nn.nn
o
C
UPPER RANGE VAL
nn.nn
o
C
ENTER
ENTER
INITIALIZE MODE:
→ LOW
HIGH
ENTER
FAIL MODE:
→ LOW
HIGH
LAST
ENTER
ENTER
SECONDARY UNITS
nnnnnn
ENTER
ENTER
SECONDARY L.R.
_nn.nn UNITS
SECONDARY U.R.
nn.nn UNITS
ENTER