PTH PRESSURE TRANSMITTER
CREATE/MODIFY CONFIGURATION
D - 4
Refer to the Platinum Standard Series Smart Pres-
sure Transmitter PTH instruction for mode descrip-
tion.
Make a selection using the arrow keys.
This is a 6-character alphanumeric designation to
represent values in user familiar units.
To select a character, press the key that has the
desired character. Continue to press the key until the
desired character appears. Use the right arrow key to
move to the next character. Use the left arrow key to
go back to the previous character.
Specify values using the number keypad. The UNITS
displayed will be those designated in the previous
screen. After entering value press .
Lower and upper temperature alarms are user con-
figurable alarms. The temperature is based on the
cell. The default alarms setting are shown here. The
defaults are also the lower and upper limits of the
alarm.
NOTE: Use
to return to a previous configura-
tion screen from any screen in the configuration pro-
cess.
Select YES.
Key Display Comments
ENTER
INITIALIZE MODE:
→ LOW
HIGH
ENTER
FAIL MODE:
→ LOW
HIGH
LAST
ENTER
ENTER
SECONDARY UNITS
_nnnnnn
ENTER
SECONDARY L. R.
nn.nn UNITS
SECONDARY U. R.
nn.nn UNITS
ENTER
ENTER
LOWER TEMP ALARM
-40.00°C
UPPER TEMP ALARM
85.00°C
BACK
ENTER
STORE THIS
CONFIGURATION?
NO
→ YES
ENTER
ID TAGNAME
READY
To Next Page
Loading...
