EQN TEMPERATURE TRANSMITTER
CREATE/MODIFY CONFIGURATION
H - 3
Select 100Ω Pt 385 type.
Select 2-WIRE.
Choose the desired temperature unit.
Select LINEAR.
If FUNC GENERATOR is selected, specify 5 input
and output points between 0 and 100%.
Refer to the Smart Electronic Temperature Trans-
mitter EQN instruction for description.
Enter a value between 0 and 32. Refer to the Smart
Electronic Temperature Transmitter EQN instruc-
tion for description.
Enter the lower range temperature value and press
. Input the upper range value.
Refer to the Smart Electronic Temperature Trans-
mitter EQN instruction for description.
Key Display Comments
ENTER
RTD TYPE
→ 100Ω Pt 385
100Ω Pt 392
ENTER
NUMBER OF ELEMENTS:
→ 2-WIRE
3-WIRE
DUAL
ENTER
ENGINEERING UNITS
→ °C
°F
°K
ENTER
OUTPUT TYPE:
→ LINEAR
FUNC GENERATOR
ENTER
OUTPUT ACTION:
→ NORMAL
REVERSE
ENTER
DAMPING:
(0-32 SEC)
_nn.nn SECS
ENTER
LOWER RANGE VAL.
nn.nn UNITS
UPPER RANGE VAL.
nn.nn UNITS
ENTER
ENTER
INITIALIZE MODE:
→ LOW
HIGH
To Next Page
Loading...
