INTRODUCTION
O - 1
APPENDIX O - STT04 DOWNLINK SOFTWARE
INTRODUCTION
This appendix covers the functions of the STT04 DownLink software.
The software is used in conjunction with the STT04 terminal. Down-
Link software features include:
• PC to STT04 interface.
• STT04 firmware upgrades via the internet.
• Upload and download device configurations from PC.
• Create configuration databases on PC.
The software is provided on a CD and is shipped with the STT04 ter-
minal. Software installation is detailed in Section 3.
NOTE: If you do not have DownLink software, contact the nearest
ABB sales office for availability.
SECURITY
An assigned user name and password are required to access Down-
Link software. The administrator can choose to bypass the password
feature of DownLink software. User names and passwords are
assigned with the Password program. Access to the Password pro-
gram requires the Password Key disk. Only personnel at the highest
security level should have access to the Password Key disk in order
to ensure security.
Starting the Password Program
After installing the software, the password program should be setup in
order to access the features of DownLink software.
1. Click Start and select Programs.
2. Highlight ABB and select Password.
Adding a User
Use this function to add a user to the STT04 DownLink software.
1. Start the Password program. Refer to Starting the Password
Program.
2. Insert the Password Key disk into a floppy disk drive.
3. Click Key and type the appropriate disk drive letter (i.e., A:) and
click Verify. The screen shown in Figure O-1 appears.
To Next Page
Loading...
