ABB STT04 - Page 269

Worksheet
STT04
BCN Smart Electronic Pressure Transmitter Configuration
IDTAG (≤14 digits, alphanumeric)
MODE □ Analog □ Digital ____ Channel Number
OUTPUT TYPE □ Linear
1
□ 5/2 Flow Mode
□ Function Generator
□ Square root
□ Vol./Sphere
□ 3/2 Flow Mode
□ Vol./Cylinder
FUNCTION GENERATOR
Input _______%
_______%
_______%
_______%
_______%
_______%
Point 0
Point 1
Point 2
Point 3
Point 4
Point 5
Output _______%
_______%
_______%
_______%
_______%
_______%
Point 0
Point 1
Point 2
Point 3
Point 4
Point 5
OUTPUT ACTION □ Normal
1
□ Reverse
DAMPING _______ sec (0.00
1
to 32.00 sec)
ENGINEERING UNITS □ iH
2
O
1
□ mmHG □ cmH
2
O
□ psi □ MPA □ kPa
□ BARS □ mBARS □ kg/cm
2
LOWER RANGE VALUE _______ Specified LRV
UPPER RANGE VALUE _______ Specified URV
INITIALIZE MODE
2
□ Low □ High
FAIL MODE
2
□ Low □ High □ Last
SECONDARY UNITS _______ Secondary LRV
_______ Secondary URV
NOTES:
1. Default parameters.
2. Select to maintain safe operation during start-up and diagnostically detected failures of the transmitter.