ABB STT04 - Page 42

OPERATING PROCEDURES
SELECTING CHARACTERS FROM THE KEYPAD
4 - 5
For this example, use the configuration ID tag name
of W1.
Press the 2 key and a 2 appears in the first character
place.
Press the 2 key again and the letter V appears in the
first character place.
Press the 2 key again and the letter W appears in the
first character place.
The cursor is in the second character position.
Press the 1 key and the number 1 appears in the
second character position.
Press and abort this configuration.
Key Display Comments
ENTER
STT04 CONFIGURATION
[_
]
←PREVIOUS NEXT→
V W X
2
STT04 CONFIGURATION
[ 2 ]
←PREVIOUS NEXT→
V W X
2
STT04 CONFIGURATION
[V ]
←PREVIOUS NEXT→
V W X
2
STT04 CONFIGURATION
[ W ]
←PREVIOUS NEXT→
STT04 CONFIGURATION
[ W_ ]
←PREVIOUS NEXT→
1
S T U
STT04 CONFIGURATION
[ W1 ]
←PREVIOUS NEXT→
ENTER
SELECT MODE:
→ ANALOG
DIGITAL
CLEAR