Operation Manual / TPL73-B.. - 85-B11/ -B12
8 Disassembly and assembly / 8.6 Removing cartridge group
© Copyright 2018 . All rights reserved. HZTL2480_EN Revision D July 2018
Compressor casing in-
ternal part
u Fit support angle (90025).
u Place the compressor casing internal part (76000) with the wall insert
(77000) and the diffuser (79000) down on the support angle and an
underlay.
u Remove the O-ring (76040).
u Loop the lifting device around the rear of the flange (F).
u Carefully rotate the compressor casing internal part with wall insert
and diffuser over the support bracket (90025) and set it down with
the front side of the flange (F) on the underlay.
WARNING
Make sure that the underlay does not slip.
u Rest the compressor casing internal part only on flange F.
u Check underlay and adjust if necessary.
Page 104 / 151
To Next Page
Loading...
