- 87 -
000514AG
Settings
Selecting Settings brings up the rst screen relating to the password.
The default password is "0000".
This can be changed by using the display buttons, following the same
procedure as always:
• ENTER scrolls through the digits (from left to right)
• ESC returns to the previous digit (from right to left)
• Press ESC several times to return to the previous menus
• DOWN scrolls down the numerical scale (from 9 to 0)
• UP scrolls up the numerical scale (from 0 to 9)
After entering the password, press ENTER to access the information in
this section:
Settings
Input UV Delay
Service
Remote ON/OFF
MPPT Scan
Power Limit.
Autotest
Vstart
DOWN
ENTER
Password 0000
ENTER
UP
1
DOWN UP
DOWN UP
DOWN UP
DOWN UP
DOWN UP
DOWN UP
2
3
4
5
6
Reactive Power
DOWN UP
7
8*
Alarms
9
DOWN UP
Stand Alone
10**
(*) Available for the Italian country
standard only. Refer to the section
on this topic in the manual.
(**) Available only if the "Stand
Alone" accessory board has been
installed in the unit. Refer to the
section on this topic in the manual.
Скачано с сайта интернет магазина https://axiomplus.com.ua/
To Next Page
Loading...
